English -
9
Operator's Manual CS 2512
Introduction
Husqvarna CS 2512 is designed for use together with the
hydraulic unit PP 455 E or Husqvarna RC 455. Husqvarna
CS 2512 is a powerful and easy to use wire saw with a
capacity for really large work, yet at the same time
sufficiently compact and mobile for small work. It can be
used in many different ways, both on the ground and fitted
to the wall.
The well thought-out design of the CS 2512, where the
drive wheel is placed on the machine's output side means
that the wire is always under tension even when the feed
force is low. Combined with the adjustable pressure valve
this gives exact control of cutting and unbeatable
performance.
The machine can be rigged both vertically and horizontally
and many cuts can be made directly without external idler
wheels.
Complete saw equipment consists of:
1 x saw unit
1 x accessory box
1 x 18 mm wrench
1 x pressure reduction block
1 x extra wear rubber for the magazine wheel
1 x cleaning brush
To Next Page
Loading...
Need help?
General