Husqvarna-25
OPERATION
8058-019
Set mower deck to transport position
8058-020
Pull parking brake upwards to activate.
8052-001
Depress blade switch
Before Starting
• Read the sections Safety and Controls sections
before starting the machine.
• Perform the daily maintenance before starting
(see Maintenance Schedule in the Maintenance
section).
• Check that there is sufficient fuel in the fuel tank.
• Adjust the seat to the desired position.
The following conditions must be fulfilled before the
engine can be started:
• The blade switch for engaging the mower blades
must be depressed.
• The parking brake must be on.
• Both steering controls must be in the locked
(outer) neutral position.
Starting the Engine
• Sit on the seat.
• Raise the mower deck by pushing the release
button on the top of the lifting lever. Pull the lifting
lever backward to the locked position (transport)
position.
• Activate the parking brake by pushing the release
button in and pulling the lever fully upwards.
Disengage the mower blades by pressing the blade
switch downwards.
To Next Page
Loading...
