Husqvarna-33
OPERATION
Moving Machine By Hand
ZT-2800 Bypass Linkages
When pushing or pulling the mower, engage the
ZT-2800 bypass linkages. The ZT-2800 hydro release
levers are located on the rear of the frame, below the
rear engine guard.
1. Raise the deck into the highest cutting
position.
2. Pull the ZT-2800 release levers up and out of
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
3. To re-engage the ZT-2800 to drive, reverse the
above procedure.
Load the machine into truck or trailer by driving up
ramps in low gear. DO NOT LIFT! The machine is not
intended to be lifted by hand.
8058-032
ZT-2800 engaged - left side
8058-033
Bypass linkage, left side, locked in the bypass position
WARNING!
Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the parking brake activated
To Next Page
Loading...
