44-Husqvarna
LUBRICATION
General
Remove the ignition key to prevent unintentional
movements during lubrication.
When lubricating with grease, unless otherwise
stated, use a high grade molybdenum disulphide
grease.
For daily use, the machine should be lubricated
twice weekly.
12/12 Every year
1/52 Every Week
1/365 Every day
Lubricate with grease gun
Oil change
Filter change
Level check
8051-051
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts
or the drive surfaces on the belt pulleys. Should this
happen, attempt to clean them with spirits. If the belt
continues to slip after cleaning, it must be replaced.
Petrol or other petroleum products must not be used
to clean belts.
*
Change transmission filter
To Next Page
Loading...
