EasyManua.ls Logo

Husqvarna FX 350 2022 - User Manual

Husqvarna FX 350 2022
158 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER'S MANUAL 2022
FC 350
FX 350
Art. no. 3402534en

Table of Contents

Questions and Answers

  • W
    wmannAug 5, 2025
    Why my Husqvarna Motorcycle has high oil consumption?
    • L
      Loretta JohnsonAug 5, 2025
      If your Husqvarna Motorcycle has high oil consumption, the engine vent hose might be bent; route it without bends or replace it if necessary. The engine oil level might be too high, so check it. The engine oil might be too thin (low viscosity), so change the engine oil and oil filter, and clean the oil screen. Lastly, the piston or cylinder might be worn, so measure the piston/cylinder mounting clearance.
  • D
    David GillAug 10, 2025
    What to do if malfunction indicator lamp lights up on Husqvarna FX 350 2022 Motorcycle?
    • V
      Vanessa SmithAug 10, 2025
      If the malfunction indicator lamp lights up or flashes on your Husqvarna Motorcycle, it could be due to an error in the electronic fuel injection. Inspect the wiring for any damage and check the electrical plug-in connections for corrosion or damage. Also, read out the fault memory using the Husqvarna Motorcycles diagnostics tool.
  • A
    amydiazAug 14, 2025
    Why my Husqvarna Motorcycle engine does not turn when the start button is pressed?
    • C
      Caroline PetersonAug 14, 2025
      If your Husqvarna Motorcycle engine does not turn when you press the start button, it could be due to several reasons. You may not be following the correct start procedure. The 12 V battery might be discharged, requiring you to charge it, check the charging voltage, open-circuit current and the alternator's stator winding. The main fuse could be blown, so replace it. The starter relay or the starter motor could be defective and need to be checked.
  • J
    jonathanbutlerAug 18, 2025
    Why does my Husqvarna FX 350 2022 engine overheat?
    • T
      Tommy HuynhAug 18, 2025
      If your Husqvarna Motorcycle engine overheats, it could be due to several reasons. There might be too little coolant in the cooling system, so check for leakage and the coolant level. Insufficient air stream can also cause overheating, so switch off the engine when standing. Dirty radiator fins can restrict cooling, so clean them. Foam formation in the cooling system can also cause overheating, so drain and refill the coolant.
  • M
    Morgan VasquezAug 23, 2025
    Why does my Husqvarna FX 350 2022 engine has too little power?
    • B
      Brett MullinsAug 23, 2025
      If your Husqvarna Motorcycle engine has too little power, the air filter might be very dirty, requiring cleaning of the air filter and air filter box. The fuel filter could also be very dirty, so replace it. There may be a malfunction in the electronic fuel injection, which requires reading the fault memory using the Husqvarna Motorcycles diagnostics tool. The exhaust system could be leaky or deformed, or have too little glass fiber yarn filling in the main silencer, so check for damage and replace the glass fiber yarn filling. Finally, the valve clearance might be too little, so adjust it.
  • S
    sparkssarahAug 31, 2025
    Why is my Husqvarna FX 350 2022 Motorcycle 12 V battery discharged?
    • L
      Lori BridgesSep 1, 2025
      If your Husqvarna Motorcycle 12 V battery is discharged, it might not be charging, so check the charging voltage and the stator winding of the alternator. An unwanted electrical power consumer could also be draining the battery, so check the open-circuit current.
  • S
    sarahstoutNov 25, 2025
    What to do if Husqvarna FX 350 2022 engine turns but does not start?
    • E
      edwardsjohnNov 26, 2025
      If your Husqvarna Motorcycle engine turns but does not start, it could be due to several reasons. Ensure the quick release coupling is joined. A clogged fuel screen in the quick release coupling can prevent starting, so replace the fuel screen. An incorrectly set idle speed can be the issue, so adjust it. A sooty or wet spark plug can cause starting problems, so clean and dry it, or replace if necessary. If the plug gap of the spark plug is too wide, adjust it to the guideline of 0.8 mm (0.031 in). A frayed short-circuit cable in the wiring harness or a faulty stop button can also be the cause, so check the wiring harness and the electrical system. Lastly, a malfunction in the electronic fuel injection could be the reason, so read out the fault memory using the Husqvarna Motorcycles diagno...

Summary

SAFETY ADVICE

Safe operation

Provides essential guidelines for operating the vehicle safely.

CONTROLS

PREPARING FOR USE

Advice on preparing for first use

Provides critical advice before operating the motorcycle for the first time.

Running in the engine

Guides on the proper procedure for engine break-in.

RIDING INSTRUCTIONS

Checks and maintenance measures when preparing for use

Lists essential checks before starting each ride.

Starting the vehicle

Explains the correct procedure for starting the motorcycle's engine.

Shifting, riding

Provides guidance on gear shifting and riding techniques.

Refueling

Details the safety precautions and procedure for refueling.

SERVICE SCHEDULE

Required work

Lists maintenance tasks required at specific intervals.

Recommended work

Suggests additional maintenance for optimal performance.

TUNING THE CHASSIS

Air suspension XACT 5548

Describes the air suspension system used in the fork.

Adjusting the low-speed compression damping of the shock absorber

Details how to adjust the shock absorber's low-speed compression.

Adjusting the fork air pressure

Explains the procedure for adjusting the fork's air pressure.

SERVICE WORK ON THE CHASSIS

Installing the shock absorber

Instructions for correctly installing the rear shock absorber.

BRAKE SYSTEM

Checking the front brake fluid level

Procedure for verifying the front brake fluid level.

Changing the brake linings of the front brake

Steps for replacing the brake linings on the front brake.

Checking the rear brake fluid level

Procedure for verifying the rear brake fluid level.

Checking the brake linings of the rear brake

Method for checking the minimum thickness of rear brake linings.

WHEELS, TIRES

COOLING SYSTEM

TUNING THE ENGINE

SERVICE WORK ON THE ENGINE

Changing the engine oil and oil filter, cleaning the oil screen

Comprehensive guide to changing engine oil and filter.

TECHNICAL DATA

Engine

Specifications related to the motorcycle's engine.

Chassis

Technical specifications for the motorcycle's chassis components.

Husqvarna FX 350 2022 Specifications

General IconGeneral
BrandHusqvarna
ModelFX 350 2022
CategoryMotorcycle
LanguageEnglish

Related product manuals