5118384-02
AIR CUSHION GASOLINE TRIMMER
OPERATOR MANUAL
HVT40
READ THESE INSTRUCTIONS
CAREFULLY!
KNOW YOUR CONTROLS.
LEARN HOW TO STOP YOUR
TRIMMER IN AN EMERGENCY
PREPARATION
Before using your new Husqvarna Hover
Trimmer, make a careful note of the
details on the serial number label, which
can be found on the rear of the deck.
Always quote these details to your dealer
when enquiring about spares and
service.
CARRYING THE TRIMMER
NOTE:
Before carrying the machine from one
trimming area to another, disconnect the
spark plug lead.
Carry the trimmer at the point of balance
(see illustration) with the cutting head
away from you.
NEVER CARRY THE TRIMMER WHEN
IT IS RUNNING.
Upper Handle
Start/Stop
Switch
Lower Handle
Tank Cap
Air Cleaner
Primer
Deck
Spark Plug/Lead
Starting Handle
Bolt, washer
and Lock nut
The handle position can be altered by
moving it forward for the park position or
back for the trimming position.
Park Position
Trimming Position
ASSEMBLY OF LOWER
HANDLE TO DECK
With the trimmer on the ground:
1.Remove the bolts (1), washers (2) and
lock nuts (3) from the polythene bag.
2.Place one washer (2) on to the bolt (1)
and secure the lower handle (4) by
placing bolts (1) through deck brackets
(5) and lower handle (4).
3.Place washer (2) on bolt and secure
with lock nut (3).
Assemble upper handle (6) to lower
handle (7) by fitting bolts (8) and washers
(9) and securing with lock nuts (10).
ASSEMBLY OF UPPER
HANDLE TO LOWER HANDLE
HANDLE POSITION
Tie
wraps
Bolt,
washer
and
Lock nut
1
2
3
4
5
6
7
8
10
9
Debris Guard
2
To Next Page
Need help?
General