Husqvarna Jonsered CS 2245 - Throttle Lock and Trigger

22 – English
Safety equipment
3
Dismantle the handle insert (B) by loosening the
screw C on the handle. (see fi gure
18)
B
C
D
4
Press out the throttle control pin (D) with the help
of a punch. (see fi gure 19)
5
Loosen the throttle lock as illustrated with the help
of a screwdriver or the like. Then dismantle from
the shaft in the handle. (see fi gure
20)
6
Dismantle throttle cable and throttle control.
6.9 Throttle lock, throttle trigger and
return spring – removal
1
Loosen the throttle cable on the carburettor, the
fuel hose and suction hose to the fuel pump.
2
Dismantle the tank unit from the engine unit by
loosening the screws A and E (see fi gure 17)
A
2xA
A
A
A
Fig 17
Fig 18
Fig 19
Fig 20