EasyManua.ls Logo

Husqvarna Jonsered CS 2245 - Page 34

Husqvarna Jonsered CS 2245
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
34 – English
Repair instructions
Function
The carburettor operates differently in the following
modes:
Cold start mode
• Idling mode
Part throttle mode
Full throttle mode
In the cold start mode (see gure) the choke valve
(H) is fully closed. This increases the vacuum in
the carburettor so that fuel is sucked more easily
from all the diffuser jets (D, E and F). The throttle
valve (I) is partly open. Extra air inlet (J) is closed.
(see gure
25)
In the idling mode (see gure) the throttle valve (I
and J) is closed and the choke valve (H) is open.
Air is sucked in through an aperture in the throttle
valve and a small amount of fuel is supplied th-
rough the diffuser jet (D). (see gure 26)
F
E
I
H
G
D
J
J
I
D
H
E
I
H
D
F
E
G
D
H
I
J
In the part throttle mode (see gure below) the th-
rottle valve (I) is partially open and the choke valve
(H) is open. Fuel is supplied through the diffuser
jets (D and E). The throttle valve (J) starts to open.
(see gure 27)
In full throttle mode (se gure below) all valves
are open and fuel is supplied through all diffuser
jets (D, E, F and G). Extra air inlet (J) is also fully
opened. (see gure 28)
Fig 27
Fig 26
Fig 25
Fig 28

Table of Contents

Related product manuals