OPERATION
27
Before Starting
• Read the sections Safety Instructions and
Controls before starting the machine.
• Perform the daily maintenance before starting
(see maintenance schedule in the Maintenance
section).
• Check that there is sufficient fuel in the fuel tank.
• Adjust the seat to the desired position.
The following conditions must be fulfilled before the
engine can be started:
1. The blade switch for engaging the mower
blades must be depressed.
2. The parking brake must be on.
Roll Bar and Safety Belt
Operate the unit with the roll bar in the raised and
locked position and use the seat belt. There is no
rollover protection when the roll bar is down. If it is
necessary to lower roll bar, do not wear the seat
belt. Raise the roll bar as soon as clearance permits.
8011-464
Roll bar in upright position
WARNING!
The seat belt must be used when
the roll bar is in upright position.
8065-006
Activate parking brake before starting
8065-018
Place controls in neutral position
3. Both steering controls must be in the locked
(outer) neutral position.
To Next Page
Loading...
