Husqvarna T525 - Recommended Cutting Equipment and Filing; Recommended Cutting Equipment

Husqvarna T525
Front handle, m/s
2
4.9
Rear handle, m/s
2
5.2
Saw chain/guide bar
Type of drive sprocket/number of teeth 3/8"/Spur 6, 1/4"/Spur 8
Saw chain speed at 133% of maximum engine power
speed, m/s.
24.1
Accessories
Recommended cutting equipment
Chainsaw models Husqvarna T525 have been
evaluated for safety according to EN ISO 11681-2:2011/
A1:2017 (Machinery for forestry - Portable chainsaws -
Safety requirements and testing. Part 2: Chainsaws for
tree service) and fulfill the safety requirements when
equipped with the below listed guide bar and saw chain
combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Kickback and guide bar nose radius
Guide bar Saw chain
Length, in/cm Pitch, in Gauge, in/mm Max. nose ra-
dius
Type Length, drive
links (no.)
Low kickback
10/25 1/4 0.050/1.3 R10 Husqvarna
H00
60
12/30 1/4 0.050/1.3 R10 68
10/25 3/8 0.050/1.3 7T Husqvarna
H37
40 Yes
12/30 3/8 0.050/1.3 7T 45
10/25 3/8 0.050/1.3 7T Husqvarna
S93G
40 Yes
12/30 3/8 0.050/1.3 9T 45
The usable cutting length is usually 1 in less than the
nominal guide bar length.
Filing equipment and filing angles
Use a Husqvarna file gauge to sharpen the saw chain. A
Husqvarna file gauge makes sure that you get the
correct filing angles. The part numbers are given in the
table below.
If you are not sure how to identify the type of saw chain
on your product, refer to www.husqvarna.com for more
information.
30 1007 - 003 - 28.08.2019