Husqvarna TC 242T User Manual

4. Push the ends (B) of the front frame (C) through
the loops in the fabric.
A
D
C
C
B
E
5. Push the 2 screws (A) through the fabric (D) and
the frames.
6. Install the 2 nuts.
CAUTION: Use a maximum
torqe of 11 Nm.
7. Push the front frame into the clips (E) in the front
of the floor of the grass catcher.
8. Push the 4 clevis pins (F) through the frames and
the 2 cross braces (G).
H
H
F
F
G
9. Install the 2 retainer springs (H).
10. Push the grass catcher handle (I) through the
hole in the top of the grass catcher.
I
K
J
11. Install the clevis pin (J) and the clip (K).
To install the grass catcher brackets
1. Install the grass catcher bracket (A) and tighten
the 2 screws and the 2 nuts (B). Make sure that
the top edges of the brackets (C) align.
A
C
B
2. Install the offset strut (D) and the 4 carrage bolts
(E).
E
E
D
3. Install the 2 pivots (F).
F
H
G
4. Install the 2 washer head bolts (G).
5. Install the 4 nuts (H).
To adjust the grass catcher brackets
The position of the grass catcher brackets can be
adjusted.
1. Do the steps that follow to adjust the vertical
position of the grass catcher brackets.
12
2009 - 003 - 10.04.2023

Husqvarna TC 242T Specifications

General

Engine Manufacturer	Briggs & Stratton
Cylinder Displacement	656 cm³
Cylinders	2
Transmission Type	Hydrostatic
Transmission Manufacturer	Tuff Torq
Cutting Width	107 cm
Collector Volume	320 l
Oil Filter	Yes
Nose Roller	Yes
Seat Material	Vinyl
Seat Back Height	High
Hour Meter Type	Digital with pre-programmed service intervals
Mulch Kit	Included
Fuel Tank Volume	11.5 L
Cutting Methods	Collect, Mulch, Side discharge
Engine Lubrication Type	Full pressure
Front Tire Size	15x6-6
Wheelbase	121.9 cm