Husqvarna TC 242T User Manual

15 DEGREES MAX.
FOLD ALONG DOTTED LINE
THIS IS A 15 DEGREE SLOPE
ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL
SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION
WARNING: To avoid serious injury, operate your tractor up and
down the face of slopes, never across the face. Do not mow
slopes greater than 15 degrees. Make turns gradually to prevent
tipping or loss of control. Exercise extreme caution when changing direction on slopes.
1. Fold this page along dotted line indicated above. 2. Hold page before you so that its left edge is vertically parallel to a tree trunk or other upright structure. 3. Sight across the fold in the direction of hill slope you want to measure. 4. Compare the angle of the fold with the slope of the hill.
2009 - 003 - 10.04.2023 275

Husqvarna TC 242T Specifications

General

Engine Manufacturer	Briggs & Stratton
Cylinder Displacement	656 cm³
Cylinders	2
Transmission Type	Hydrostatic
Transmission Manufacturer	Tuff Torq
Cutting Width	107 cm
Collector Volume	320 l
Oil Filter	Yes
Nose Roller	Yes
Seat Material	Vinyl
Seat Back Height	High
Hour Meter Type	Digital with pre-programmed service intervals
Mulch Kit	Included
Fuel Tank Volume	11.5 L
Cutting Methods	Collect, Mulch, Side discharge
Engine Lubrication Type	Full pressure
Front Tire Size	15x6-6
Wheelbase	121.9 cm