Husqvarna TC 242T User Manual

8. Remove the rear discharge deflector in the
opposite sequence.
To install the grass catcher
(accessory)
The product can be used with a grass catcher.
1. Put the cutting deck in the transport position.
Refer to To set the cutting deck in transport
position or mow position on page 17
.
2. Remove the rear discharge deflector (accessory)
or the mulch plug (accessory) if it is installed.
3. Put the discharge chute through the back plate
and into the chute adaptor for the cutting deck.
4. Install the 2 wing nuts.
5. Install the grass catcher.
6. Remove the grass catcher in the opposite
sequence.
Maintenance
Introduction
WARNING: Read and understand
the safety chapter before you do
maintenance on the product.
2009 - 003 - 10.04.2023 21

Husqvarna TC 242T Specifications

General

Engine Manufacturer	Briggs & Stratton
Cylinder Displacement	656 cm³
Cylinders	2
Transmission Type	Hydrostatic
Transmission Manufacturer	Tuff Torq
Cutting Width	107 cm
Collector Volume	320 l
Oil Filter	Yes
Nose Roller	Yes
Seat Material	Vinyl
Seat Back Height	High
Hour Meter Type	Digital with pre-programmed service intervals
Mulch Kit	Included
Fuel Tank Volume	11.5 L
Cutting Methods	Collect, Mulch, Side discharge
Engine Lubrication Type	Full pressure
Front Tire Size	15x6-6
Wheelbase	121.9 cm