Husqvarna TC 242T User Manual

Maintenance schedule
Maintenance schedule Before
each
use
At inter-
vals of 8
hours
At inter-
vals of
25
hours
At inter-
vals of
50
hours
At inter-
vals of
100
hours
Each
season
Before
storage
Product Do a check of the brake
function.
X X
Do a check of tire pres-
sure.
X X
Do a check of the op-
erator presence control
(OPC).
X
Do a check of the re-
verse operation system
(ROS).
X
Do a check for loose
fasteners.
X X X
Examine the blades for
wear and damage.
X
2
Lubricate the product.
Refer to Lubrication
schedule on page 23 .
X X
Do a check of the bat-
tery level.
X
Clean the battery and
the terminals.
X X
Clean pieces off the
steering plate. Refer to
To clean the product on
page 24 .
X
Do a check of the trans-
axle cooling fan.
X
Make sure that the cut-
ting deck is level.
X
Do a check of the V-
belts.
X
2
Examine the blades more frequently if you cut where there is sand and soil.
22 2009 - 003 - 10.04.2023

Husqvarna TC 242T Specifications

General

Engine Manufacturer	Briggs & Stratton
Cylinder Displacement	656 cm³
Cylinders	2
Transmission Type	Hydrostatic
Transmission Manufacturer	Tuff Torq
Cutting Width	107 cm
Collector Volume	320 l
Oil Filter	Yes
Nose Roller	Yes
Seat Material	Vinyl
Seat Back Height	High
Hour Meter Type	Digital with pre-programmed service intervals
Mulch Kit	Included
Fuel Tank Volume	11.5 L
Cutting Methods	Collect, Mulch, Side discharge
Engine Lubrication Type	Full pressure
Front Tire Size	15x6-6
Wheelbase	121.9 cm