To engage and disengage the
parking brake
1. To engage the parking brake, push down the
brake pedal (A) fully to the lowest position.
2. With the brake pedal pushed down, pull up the
parking brake lever (B).
3. Release the brake pedal.
4. Release the parking brake lever.
Note: Make sure that the parking brake holds
the product safely.
5. To release the parking brake, push down the
brake pedal.
To stop the product
WARNING:
Always stop the
product, engage the parking brake and
remove the ignition key before you go
away from the product.
CAUTION: The exhaust gas from
the warm engine can cause burn
damage to the grass. To prevent burn
damage , to the grass, always stop the
engine when you stop the product on
grass areas.
1. Push down on the brake pedal (A) fully until the
product stops fully.
2. Disengage the cutting deck. Refer to
To engage
and disengage the cutting deck on page 19
.
3. Put the throttle control in the slow position and
let the engine operate at idle speed for some
minutes.
4. Put the cutting deck in the transport position.
Refer to
To set the cutting deck in transport
position or mow position on page 17
.
5. Turn the ignition key to the "STOP" position and
remove the ignition key from the ignition.
To use the throttle control
The throttle control adjusts the engine speed and the
speed of the blades in the cutting deck.
• Put the throttle control in the choke position (A)
when you start a cold engine. Refer to
To start a
cold engine on page 16
.
• Put the throttle control in the fast position (B) to
operate the engine at full speed. Always have the
throttle control in the fast position when you cut
grass.
• Put the throttle control in the slow position (C) to
operate the engine at idle speed.
To use the headlight
• Push the power switch to position (A) to make
the headlight come on.
• Push the power switch to position (B) to make
the headlight go off.
18
2009 - 003 - 10.04.2023
To Next Page
Loading...
Need help?
General
