To Next PageTo Next Page
Need help?Do you have a question about the Husqvarna TC 250-450-510/2008 and is the answer not in the manual?
General| Brand | Husqvarna |
|---|---|
| Model | TC 250-450-510/2008 |
| Category | Motorcycle |
| Language | English |
Defines standard street legal (limited power) and competition (full power) configurations.
Pre-ride inspection checklist for safety and performance.
Guide for the initial running-in period of the engine for longevity.
Step-by-step guide for starting the engine when cold.
Steps for starting the TXC model using starter knob and clutch.
Steps for starting TC-TXC models using starter knob and pedal.
Details for starting the TC model, including warm start preparation.
Steps for starting the TC-TXC model when hot or after a fall.
Steps for safely stopping the motorcycle and engine.
How to check the engine oil level using the inspection window.
Procedure for draining oil, replacing filters, and refilling.
Steps for draining and refilling the cooling system fluid.
How to check, clean, and replace spark plugs, including gap settings.
Steps for checking and adjusting valve clearance.
Details on measuring valve clearance using a feeler gauge and checking parts.
Step-by-step guide for bleeding air from the hydraulic clutch system.
Guidance on adjusting suspension for different track conditions.
Procedure for checking the oil level inside the front fork rods.
Steps to adjust the rear shock absorber based on rider weight and conditions.
Steps to adjust the rear shock absorber spring preload.
How to check, adjust, and lubricate the drive chain for safety.
Details on chain adjustment using screws and check nuts.
How to check chain, pinion, and sprocket wear.
Steps for removing the front wheel, including axle and caliper.
Steps for reinstalling the front wheel, brake disc, and caliper.
Steps for removing the rear wheel and chain adjusters.
How to inspect brake pad wear and service limits.
How to inspect brake pad wear and service limits for SMR models.
How to measure disc thickness and check for warpage.
Specifies the service limit for disc warpage.
How to check and change brake fluid according to the maintenance chart.
Detailed steps for bleeding the front brake system.
How to measure cylinder bore and piston diameter if mismatched.
How to measure piston diameter at specific points.
Specifies clearance values between piston and cylinder.
How to check axial play of piston rings in the groove.
How to measure the clearance between piston rings and cylinder.
Specifies nominal clearance values.
Specifies wear limits for piston ring to cylinder clearance.
How to check valve guide wear using a dial comparator.
Checks for valve shank and seat conditions, and deformation.
How to check camshaft surfaces for wear and cam height.
Table of tightening torque specifications for engine components.
Table of tightening torque specifications for chassis components.
Additional chassis tightening torque specifications.
Maintenance schedule for TE-TC-TXC models covering various intervals.
Maintenance schedule details for TE-TC-TXC models in German/Spanish.
Detailed maintenance schedule for TE-TC-TXC models with specific intervals.
Maintenance schedule for SMR and TE-TC models, covering intervals.
Detailed maintenance schedule for SMR/TE-TC models with specific intervals.
Detailed maintenance schedule for SMR/TE-TC models with specific intervals.
Detailed maintenance schedule for SMR/TE-TC models with specific intervals.
Detailed maintenance schedule for SMR/TE-TC models with specific intervals.
Detailed maintenance schedule for SMR/TE-TC models with specific intervals.
