Husqvarna TC 250 User Manual (English)

Other manuals for Husqvarna TC 250

Questions and Answers:

M
Madison ThomasAug 16, 2025
Why does my Husqvarna Motorcycle engine overheat?
- R
  robertlopezAug 16, 2025
  Your Husqvarna Motorcycle engine may overheat due to several reasons. It could be caused by too little coolant in the cooling system, requiring you to check for leaks and verify the coolant level. Insufficient air stream, necessitating that you switch off the engine when stationary, or very dirty radiator fins, which means you should clean them. Foam formation in the cooling system may also be the problem, suggesting that you drain and refill the coolant. Other potential causes include a damaged cylinder head or cylinder head gasket, advising a check, or a bent radiator hose, which requires replacement.
A
adam81Aug 19, 2025
What to do if my Husqvarna Motorcycle engine turns but does not start?
- C
  Caitlin KellyAug 19, 2025
  If your Husqvarna Motorcycle engine turns but doesn't start, consider these potential causes and solutions. First, ensure you are following the correct start procedure. If the motorcycle has been out of use for a while, old fuel in the float chamber might be the issue, so empty it. Check for any interruptions in the fuel feed, such as a blocked fuel tank breather or fuel tap. Also, a spark plug that's oily or wet should be cleaned, dried, or replaced. Make sure the spark plug electrode distance (plug gap) is correctly adjusted. Inspect the ignition system for any faults and check the kill switch for frayed cables or defects. Clean and treat any loose or oxidized connectors or ignition coils with contact spray. Finally, check for water in the carburetor or blocked jets.
J
James DavisAug 22, 2025
Why won't my Husqvarna Motorcycle engine crank with the electric starter (TX 300)?
- K
  kristen44Aug 22, 2025
  If your Husqvarna TX 300 Motorcycle engine won't crank with the electric starter, there are several possible reasons. It could be due to an operating error during the start procedure. The battery might be discharged, requiring you to recharge it and check the charging voltage, closed current, and alternator. A blown main fuse could also be the cause, so replace it. Additionally, the starter relay or starter motor might be faulty, and each should be checked.
C
Cassandra LarsonAug 26, 2025
What to do if my Husqvarna Motorcycle engine has too little power?
- B
  Bryan BarrAug 26, 2025
  If your Husqvarna Motorcycle engine has too little power, the issue could stem from a few sources. Check for an interrupted fuel feed by inspecting the fuel tank breather and cleaning the fuel tap. A very dirty air filter can also cause this, so clean the air filter and air filter box. Examine the exhaust system for leaks or deformation and consider changing the glass fiber yarn filling in the main silencer. Also, a fault in the ignition system could be the reason, or a damaged diaphragm or reed valve housing.
K
Kevin JenkinsAug 28, 2025
What to do if my Husqvarna Motorcycle engine stalls or pops into the carburetor?
- M
  Mr. Benjamin SchultzAug 28, 2025
  If your Husqvarna Motorcycle engine stalls or pops into the carburetor, it might be due to a lack of fuel, so ensure the fuel tap is in the ON or RES position and refuel if necessary. Another cause could be the engine taking in bad air, so check the intake flange and carburetor for tightness. Lastly, a loose or oxidized connector or ignition coil can cause this issue, so clean the connector and treat it with contact spray.
M
mcdonaldmichaelAug 31, 2025
How to fix a Husqvarna Motorcycle engine that does not speed up?
- S
  Sabrina BergAug 31, 2025
  If your Husqvarna Motorcycle engine does not speed up, it could be due to a carburetor running over because the float needle is dirty or worn. Also, loose carburetor jets can cause this problem. In both cases, you should check and set the carburetor components. Another potential cause is a fault in the ignition system, which requires checking the ignition system.
B
bryanboydSep 3, 2025
Why does my Husqvarna Motorcycle engine have no idle?
- A
  amberadamsSep 3, 2025
  Your Husqvarna Motorcycle engine might lack idle for several reasons. The idling jet could be blocked, so you should check and set the carburetor components. Distorted adjusting screws on the carburetor can also be the problem, so adjust the idle speed. A defective spark plug might be the cause, so replace it. Additionally, the ignition system could be defective, requiring you to check the ignition coil and spark plug connector.
H
Heidi BeltranSep 6, 2025
What causes white smoke emission (steam in exhaust gas) in Husqvarna Motorcycle?
- B
  benjamin43Sep 6, 2025
  White smoke emission (steam in exhaust gas) in your Husqvarna Motorcycle can be caused by a damaged cylinder head or cylinder head gasket. In this case, you should check the cylinder head and cylinder head gasket.
W
William WilsonSep 9, 2025
Why is gear oil exiting at the vent hose of my Husqvarna Motorcycle?
- H
  holly61Sep 9, 2025
  Gear oil exiting at the vent hose of your Husqvarna Motorcycle is likely due to too much gear oil being added. To resolve this, check the gear oil level.
E
erikjohnsonSep 12, 2025
Why is there water in the gear oil of my Husqvarna Motorcycle?
- J
  jennifer40Sep 12, 2025
  Water in the gear oil of your Husqvarna Motorcycle can be caused by a damaged shaft seal ring or water pump. You should check the shaft seal ring and water pump.

Husqvarna TC 250 Specifications

General

Displacement	249 cc
Starter	Kickstarter
Front Brake Dimensions	260 mm
Rear Brake Dimensions	220 mm
Engine Type	Single-cylinder, 2-stroke
Bore x Stroke	66.4 mm x 72 mm
Front Brake	Disc brake
Rear Brake	Disc brake
Fuel Tank Capacity	7.5 liters
Rear Suspension	WP XACT shock