To Next PageTo Next PageWhy are the headlight(s) not working on my Husqvarna TS 146XKD Lawn Mower?
If your Husqvarna Lawn Mower headlights are not working (if equipped), first, ensure the switch is turned “ON”. If not, replace the bulb(s) or lamp(s). If the issue persists, check or replace the light switch. Also, check the wiring and connections for any looseness or damage. Finally, replace the fuse if it is blown.
Why am I experiencing loss of drive on my Husqvarna Lawn Mower?
If your Husqvarna Lawn Mower experiences a loss of drive, ensure the freewheel control is in the “engaged” position. If equipped, refer to the "CLEANING" section in the Maintenance section for debris on the steering plate. Replace the motion drive belt if it is worn, damaged, or broken. If air is trapped in the transmission, purge it. If the axle key is missing, install it at the rear wheel, referring to "TO REMOVE WHEEL" in the Service and Adjustments section.
What to do if Husqvarna TS 146XKD Lawn Mower engine dies when tractor is shifted into reverse?
If your Husqvarna Lawn Mower engine dies when shifted into reverse, turn the ignition key to the ROS "ON" position while the mower or other attachment is engaged. See the Operation section for more details.
What causes the Husqvarna TS 146XKD engine to continue running when the operator leaves the seat?
If the engine continues to run on your Husqvarna Lawn Mower when you leave the seat with the attachment clutch engaged, check the wiring, switches, and connections of the operator-safety presence control system. If the issue is not corrected, contact an authorized service center/department. Do not operate the machine until the problem is resolved.
Why is my Husqvarna TS 146XKD losing power?
If your Husqvarna Lawn Mower is experiencing a loss of power, try the following: * Raise the cutting height or reduce speed if you're cutting too much grass or going too fast. * Clean the underside of the mower housing to remove any buildup of grass, leaves, or trash. * Clean or replace the air filter if it's dirty. * Check and change the oil if the level is low or the oil is dirty. * Clean and regap or change the spark plug if it's faulty. * Replace the fuel filter if it's dirty. * Empty the fuel tank and refill it with fresh, clean gas if the fuel is stale or dirty. * Empty the fuel tank and carburetor, refill with fresh gasoline, and replace the fuel filter if there's water in the fuel. * Connect and tighten the spark plug wire if it's loose. * Clean the engine air ...
General| Cutting Width | 46 inches |
|---|---|
| Transmission | Hydrostatic |
| Deck Material | Steel |
| Cutting Height Adjustment | Lever |
| Warranty | 3 years |
| Fuel Tank Capacity | 3.5 gallons |
| Blade Engagement | Electric |
| Turning Radius | 16 inch |
| Seat Type | High-back |
| Cylinder Displacement | 725 cc |
