Husqvarna TS 242TXD User Manual (English)

Other manuals for Husqvarna TS 242TXD

Questions and Answers:

N
nelsondebraAug 23, 2025
What to do if starter motor does not turn the engine over on Husqvarna Lawn Mower?
- L
  Latoya HarrellAug 23, 2025
  If the starter motor on your Husqvarna Lawn Mower isn't turning the engine over, several things could be the cause. First, ensure the battery isn't too weak by charging it. Make sure the attachment clutch control is disengaged. Also, verify that the clutch/brake pedal is fully pushed down when starting the engine. Check the battery connections for any issues. Other potential issues include a damaged main fuse (replace it). For a damaged ignition lock, safety connector for clutch/brake pedal, or starter motor/solenoid, it is recommended to consult a service agent. Also, if the operator presence control (OPC) does not operate correctly, check the wires, switches and connections and consult a service agent.
R
Randy AdamsAug 26, 2025
What to do if Husqvarna Lawn Mower battery does not charge?
- D
  Deborah BensonAug 26, 2025
  If your Husqvarna Lawn Mower battery isn't charging, several things could be the cause. First, check if the main fuse is damaged and replace it if necessary. If the battery is damaged, replace it. Ensure the charging cable is connected properly. Also, check the battery connections for any issues.
N
Nancy EspinozaAug 28, 2025
What to do if Husqvarna TS 242TXD engine becomes too hot?
- M
  marissa47Aug 28, 2025
  If your Husqvarna Lawn Mower engine is overheating, there are several things to consider. First, check if there is an overload in the engine and decrease the workload. Make sure that the air intake or the cooling fins on the engine are not blocked; if they are, clean them. Also, check the engine oil level and add oil if necessary. Other potential issues include a damaged spark plug (replace the spark plug). For a damaged cooling fan or ignition lock, it is recommended to consult a service agent.
P
pollardlisaSep 2, 2025
Why is the cutting result unsatisfactory with my Husqvarna TS 242TXD Lawn Mower?
- M
  Matthew MillerSep 2, 2025
  If you're not satisfied with the cutting result from your Husqvarna Lawn Mower, several factors could be the cause. Start by checking if the blades are blunt or damaged and sharpen or replace them as needed. If the cutting deck is not parallel, adjust it. Avoid cutting when the grass is wet. If the grass is long, begin with a high cutting height and gradually decrease it. Check the tire pressure and adjust it if necessary. Also, avoid operating the product at too high a forward or rearward speed; use a slower speed. A worn or damaged drive belt for the cutting deck (replace it).
T
Taylor NolanSep 4, 2025
Why is there vibration in my Husqvarna TS 242TXD?
- A
  Alex MclaughlinSep 4, 2025
  If you're experiencing vibration in your Husqvarna Lawn Mower, several factors could be the cause. Start by checking if the blades are loose and tighten the bolts. Also, inspect the blades for damage or imbalance and balance or replace them as necessary. Finally, make sure that the engine is not loose and tighten the engine bolts.
T
Tanya HillSep 7, 2025
Why does my Husqvarna TS 242TXD Lawn Mower move slowly or not at all?
- M
  macdonaldamySep 7, 2025
  If your Husqvarna Lawn Mower is moving slowly, irregularly, or not at all, several factors could be the cause. First, check if the product is in freewheel mode. Also, verify that the parking brake is disengaged. Other potential issues include a loose or damaged drive belt (replace it), unwanted materials on the steering plate (clean the product), or a missing square key on the axle.
J
Jessica WhiteSep 10, 2025
Why can't the blades rotate on my Husqvarna TS 242TXD Lawn Mower?
- J
  Joshua HudsonSep 10, 2025
  If the blades on your Husqvarna Lawn Mower aren't rotating, several issues could be the cause. Check for any blockage in the clutch mechanism and remove it. Other potential issues include a worn or damaged drive belt for the cutting deck (replace it), a frozen idler pulley (replace the idler pulley), or a frozen blade mandrel (replace the blade mandrel).

Husqvarna TS 242TXD Specifications

General

Engine Displacement	725 cc
Cylinders	2
Cutting Width	42 in
Cutting Height, Max	4 in
Transmission Type	Automatic
Transmission Manufacturer	Hydro-Gear
Drive	Rear-wheel drive
Blade Engagement	Electric
Turning Radius	16 in
Seat Type	High back
Deck Material	Steel
Speed	5.5 mph
Warranty	3 years
Engine	Kohler
Engine Type	4-cycle
Cutting Height, Min	1.5 in
Fuel Capacity	3.5 gal