1
2
1 23
12 – Getting Ready to Sew
CONNECTING THE FOOT CONTROL CORD
Among the accessories you will nd the foot control cord and
the power cord. Connecting the foot control cord to the foot
control is only necessary the very rst time you are going to
use the machine.
1. Take out the foot control cord. Turn the foot control over.
Connect the cord to the socket inside the space of the foot
control. Push rmly to make sure it is properly connected.
2. Lay the cord in the slot on the underside of the foot
control.
CONNECT THE POWER CORD
AND FOOT CONTROL
On the underside of the machine you will nd information
about the power supply voltage (V) and the frequency (Hz).
Before plugging in the foot control, check to ensure that it is
of type “FR2” (see underside of foot control).
1. Connect the foot control cord to the front socket on the
bottom right side of the machine.
2. Connect the power cord to the rear socket on the bottom
right side of the machine.
3. Press the ON/OFF switch to ON to turn on power and
light.
For the USA and Canada
This sewing machine has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to t in a polarized outlet only one way. If
the plug does not t fully in the outlet, reverse the plug. If
it still does not t, contact a qualied electrician to install
the proper outlet. Do not modify the plug in any way.
To Next Page
Loading...
Need help?
General
