Select fabric type and stitch
1:19
Woven Heavy and stitch
1:20
1 2
3 4
Sewing – 43
DARNING AND MENDING
Darning a small hole or a tear before it becomes larger can
save a garment. Choose a ne thread in a color as close to
your garment as possible.
1. Place the fabric in position under the presser foot.
2. Start sewing above the hole and over it.
3. Once over the hole, press Reverse. Continue sewing. The
machine sews back and forth across the hole 14 times and
then stops.
4. To repeat the stitch with the same size, press STOP.
Reposition your fabric, then step on the foot control to
sew again. The stitch will now repeat the same size darning
square. The machine will stop automatically when the stitch
is completed.
BARTACK (MANUAL)
Secure elastic ends, drapery pleats, belt loops, and pocket
corners with the same look as ready-to-wear.
1. Place fabric under the presser foot. Lower the presser
foot and press on the foot control to start sewing. Your
machine will sew a straight stitch until you touch Reverse .
2. Your machine will then sew in reverse until you touch
reverse again.
3. Your machine will then sew a zigzag, covering the straight
stitches.
4. Touch reverse to automatically tie off.
To Next Page
Loading...
Need help?
General
