GENERAL UPKEEP, CLEANING
AND
ROUTINE MAINTENANCE
CARE AND CLEANING
To insure good sanitation,
appearance, and minimum
maintenance, the cabinet should be
cleaned and washed regularly as
use demands. Clean with mild
detergent and warm water. DO
NOT USE AN ABRASIVE
CLEANER OR STEEL WOOL, AS
THEY WILL MAR THE FINISH.
ROUTINE MAINTENANCE
♦ Under normal conditions, after
the cabinet is installed and
running, very little
maintenance should be
required. However, the
following list of housekeeping
practices will assure trouble-
free operation.
♦ Check operation of condenser
fan motor. Fan blade must turn
freely.
♦ The condenser is of bare-tube
construction on the LBN-4
through –8 to reduce the
amount of maintenance
required, and fin-and-tube
construction on the LBN-10. To
keep the cabinet at top
efficiency, periodic cleaning is
required. To ease in the
cleaning of the bare-tube
condenser, the top of the
condenser shroud is removable.
Slit the upper corners of the
gasket on the front of the
condenser, remove the screws
holding the shroud top into the
shroud ends, and remove the
top to gain full access to the
condenser.
♦ The glass lids are made of
tempered, non-heated glass.
The lids slide up to open and
can be locked open for product
loading. The lids are not self-
closing. The lids will close
easily by hand and with the
assistance of gravity. There is
a nylon glide on the edge of the
glass to assist in closing. The
lid tracks must be cleaned
periodically to allow the lids to
close freely.
♦ Manually defrost cabinet as
usage dictates. The LBN series
8
To Next Page
Loading...
