Hussmann LBN - Compressor Replacement Procedure; Internal Leak Warranty Policy

♦ After March 16, 1991 when all
cases have the five-year
warranty as standard, the
following procedure applies:
♦ Contact your Hussmann
Distributor for instructions on
returning in-warranty parts.
♦ Warranty parts must be
returned to the factory within
30 days of date of failure to
assure proper disposition.
FORWARD TO YOUR NEAREST
HUSSMANN DISTRIBUTOR:
a) The cabinet model and serial
number
♦ Lack of any of the information
may result in the shipment of
the wrong part, or a delay in
shipment.
b) A copy of the wholesaler’s
invoice, along with a copy of the
salvage value credit.
COMPRESSOR
REPLACEMENT PROCEDURE
INTERNAL LEAK WARRANTY
POLICY
♦ Replacement compressors will
not be shipped from the
Hussmann factory. They may
be obtained from your nearest
Copeland wholesaler.
♦ The LBN series are warranted
from the date of factory
shipment for five years for an
internal leak. An internal leak
not only includes the cold-wall
tubing but the upper evaporator
as well on these models.
♦ Your wholesaler will replace,
free of charge, any compressor
found to be defective within
twelve months of installation,
not to exceed twenty months
from the date of manufacture,
as determined by the
compressor serial number on
the compressor serial plate.
♦ If it is felt that there is an
internal leak in the cabinet,
care should be taken to actually
determine that there is a leak.
♦ To do this properly, the
cabinet’s evaporator section
must be isolated from the
condenser section.
♦ For any defective compressor
beyond the twelve or twenty
month time period, a salvage
value credit will be given too
partially offset the invoice for
the replacement.
♦ Unbraze the tubes going into
the back of the cabinet at the
end of the heat exchanger.
♦ Pinch or cap the larger tube and
braze shut.
23