EasyManua.ls Logo

Hussmann microSC MDN-BA - Electrical; Refrigeration; Merchandiser Electrical Data; Field Wiring; Electrical Connections

Hussmann microSC MDN-BA
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P/N 9FQ-6-P110-075-00_B 2-1
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Open Vertical Merchandisers
ELECTRICAL / REFRIGERATION
MERCHANDISER ELECTRICAL DATA
Refer to merchandiser serial plate for electrical
information.
FIELD WIRING
Field wiring must be sized for component
amperes stamped on the serial plate. Actual
ampere draw may be less than specified.
ELECTRICAL CONNECTIONS
All wiring must be in compliance with NEC
and local codes. Self contained models are
electrical cord connected at the electrical box.
Ensure ground pin is attached. For any
questions, contact the supplier or dealer where
you purchased the product or licenced service
provider.
This unit uses a powercord with NEMA (L6-20P)
plug. The powercord is rated for 20A/208-230V.
ELECTRICAL OUTLET:
Before the merchandiser is connected to any
wall circuit, use a voltmeter to check that the
outlet is at 100% of the rated voltage. The wall
circuit must be dedicated for the merchandiser.
Failure to do so voids the warranty. Do not use
an extension cord. Never plug in more than one
merchandiser per electrical circuit.
• Always use a dedicated circuit with the
amperage stated on the unit.
• Plug into an outlet designed for the plug.
• Do not overload the circuit
• Do not use long or thin extension cords.
Never use adapters.
• If in doubt, call an electrician.
Ensure ground pin is attached.
For any questions, contact the supplier or dealer
where you purchased the product or licenced
service provider.
POWER SWITCH
The main ON/OFF switch is located on the
front control on the bottom, righthand-side
of merchandiser. This is not the main power
switch. Power will continue to run through the
case until main plug is unplugged.
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES
Risk of Electric Shock. If cord or plug
becomes damaged, replace only with
a cord and plug of the same type.
DANGER
!
DANGER
!
CAUTION
!
WARNING
!
NOTE
NOTE
STOP
STOP
IMPORTANT
ATTENTION
INSTALLER
NOTICE
Merchandiser must be grounded.
Do not remove the power supply cord ground.
DANGER
!
DANGER
!
CAUTION
!
WARNING
!
NOTE
NOTE
STOP
STOP
IMPORTANT
ATTENTION
INSTALLER
NOTICE

Related product manuals