1-2 INSTALLATION
P/N 9FQ6P11007900_B U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com
LOCATION (Continued)
Product should always be maintained at proper temperature. This means that from the time the
product is received, through storage, preparation and display, the temperature of the product must
be controlled to maximize the life of the product.
be sure to position self contained merchandisers properly.
SELF CONTAINED models have vented base panels to allow air circulation through the
condensing unit.
Allow for a minimum of 2 inches of clearance from walls, merchandisers, and any other large objects
near the merchandiser’s vented base panels. A minimum space of 2 inches should be left above
the case. Blocking or restricting air flow will adversely affect performance and may damage the
refrigeration system.
If the merchandiser is used or stored in a hot spring or coastal area, it may be damaged (due to
sulfur or salt). If the intention is to install the merchandiser in any of the above areas or locations,
contact the supplier or dealer where you purchased the merchandiser. Do not lay the case sideways
to move the case. This may cause damage. Case should be installed on a flat, level floor.
After installation, fix the case in place with the leveling legs (case option) to make sure that it does
not move. Or if the case has casters, lock the casters.
Do not store items or ammable materials
atop the unit.
DANGER
!
DANGER
!
CAUTION
!
WARNING
!
NOTE
NOTE
STOP
STOP
IMPORTANT
ATTENTION
INSTALLER
NOTICE
Leveling Legs or Casters
Ground wire
Air inlet
Do not block this inlet
or the merchandiser
will not cool properly
Air Exhaust
(Optional)
Hanging
Wall
Floor
2-inch gap
required
(51 mm)
2-inch gap
required
(51 mm)
Wall
To Next Page
Loading...
