P/N 9FQ6P11007900_B 2-9
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Open Vertical Merchandisers
SHELVES
Shelves should be loaded so that the product
does not extend over the front edge of the shelf.
Product loaded over the edge will interfere with
air circulation in the cabinet.
• Display items in such a way that will not protrude
from the shelf / deck pan.
• Display the items uniformly on shelf / deck pan.
• Do not place items more than 155 lbs on deck pan
and shelf.
• After removing the items, adjust the height and
angle of the shelf.
• Adjust height and angle according to the product.
• The shelf height can be adjusted at 0.59 inch
intervals.
• Change the angle of the shelf with the hook as the
fulcrum.
STOCKING
Product should NOT be placed inside the
merchandisers until merchandisers are at proper
operating temperature.
Allow merchandiser 24 hours to operate before
loading product. Proper rotation of product
during stocking is necessary to prevent product
loss. Always bring the oldest product to the front
and set the newest to the back. Air discharge
and return flues must remain open and free
of obstruction at all times to provide proper
refrigeration and air curtain performance. Do
not allow product, packages, signs, etc. to block
the air inlet and air outlet.
Do not use unapproved shelving, baskets, display
racks, or any accessory that could hamper air
curtain performance. Contact your Hussmann
representative for more information.
DRAIN WATER
If the evaporation mechanism is attached,
drainage work is unnecessary if the outside air
temperature is 80°F, the humidity is 55% RH, and
the ambient wind speed is less than 47.2 FPM.
During the summer and on high-humidity days,
check the overow drain pan at the bottom of the
case, and throw out any excess water (See location
illustration on Page 1-3).
RE-START
Leave the product in the case for at least
5minutes before re-starting the case.
If the merchandiser is re-started immediately
after stopping, the overload protection unit or a
breaker for wiring may trip, or an excessive load
may be applied to the compressor, which will
result in failure.
For energy savings:
Please turn off the lights at night and at the time
of closing the store. When night curtains are
provided, pull them down during off hours to
enhance product quality.
Do not block the discharge air outlet
and return air inlet with products.
A clearance of 2.5
inches is needed near
the ends in order to
maintain air ow
and proper cooling
performance.
To Next Page
Loading...
