P/N 3034041_D 25
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
VRM Merchandisers
CARE AND CLEANING
Long life and satisfactory performance of
any equipment is dependent upon the care it
receives. To ensure long life, proper sanitation
and minimum maintenance costs, this unit
should be thoroughly cleaned, all debris
removed and the interiors washed down.
Cleaning often will control or eliminate odor
buildup. Frequency of cleaning is dependent
on usage and local health requirements.
Exterior Surfaces
The exterior surfaces must be cleaned with a
mild detergent and warm water to protect and
maintain their attractive finish.
neVer use AbrAsiVe cleAners or scouring
pAds. neVer use cAustic sodA, kerosene,
gAsoline, thinner, solVents, detergents,
Acids, chemicAls or AbrAsiVes. do not use
AmmoniA-bAsed cleAners on Acrylic pArts.
Interior Surfaces
do not use AmmoniA-bAsed products to
cleAn light shields. neVer use AbrAsiVe
cleAnsers or scouring pAds.
The interior surfaces may be cleaned with most
domestic detergents and sanitizing solutions
with no harm to the surface. Always read and
follow the manufacturer’s instructions when
using any cleaning product.
Inspect all LED connections and plug/
receptacles for signs of arcing. Replace any
component that shows signs of arcing. Make
sure all unused receptacles have close-off covers
securely attached.
CLEANING UNDERNEATH THE CASE
The case can be moved to facilitate cleaning.
Unplug the merchandiser, and move it out if
the way in order to sweep and mop the area
underneath the case. Brush away all dirt and
liter from the area. Ensure there is no dirt
build up around the bottom of the case or near
the intake or exhaust.
MAINTENANCE
Do not use HOT water on COLD glass surfaces.
This can cause the glass to shatter and could
result in personal injury. Allow glass fronts,
ends and service doors to warm before applying
hot water.
To reduce the risk of fire, electrical shock or
injury when cleaning this merchandiser:
• Unplug the merchandiser before cleaning;
• Keep all liquids away from electrical and
electronic components;
• Do not use any mechanical device or other
means to speed the defrost process, except
as recommended by the manufacturer.
To Next Page
Loading...
