REV B 8-2 125816
NOTES:
1. Initial engine oil change is after 5 hours of operation. Thereafter, change oil after every 40 hours operation. Change more often under dusty or
dirty conditions and during hot weather periods. Hustler
®
Motor Oil is recommended.
2. Torque initially and after first 2 hours of operation.
3. Perform initial hydraulic oil and filter change after 50 hours (one week) of operation. Thereafter, change oil annually or every 500 hours
whichever comes first. Hustler
®
Full Synthetic 20W50 Hydrostatic Transmission Oil is recommended.
4. Change engine oil filter per the engine manufacturer’s recommendations. Refer to Engine Owner’s Manual for recommendations and other
maintenance items.
5. Service more often under dusty or dirty conditions. Use caution when servicing to prevent dust contamination in the engine. Do not clean filter
element. Replace with a new one.
6. Pump drive belt only - Inspect every 100 hours and replace if worn or cracking is noticed. Check spring tension adjustment. Otherwise, replace
belt every 400 hours or 2 years whichever comes first. Check and adjust the spring tension after 50 hours of use as outlined in the Hydraulic
Pump Belt Adjustment section of the Super 104™ General Service Manual (p/n 125816).
7. Check fuel system for any crack or leaks including, but not limit to, fuel line hoses, fuel valve, vent line hoses, vent valve, vapor valve, carbon
canister, and grommets. Replace as needed.
8. More often under dusty or dirty conditions and during hot weather.
9. Inspect ROPS after the first 20 hours of operation and then after every 500 hours of operation or yearly whichever comes first.
10. Refer to engine owner’s manual for engine service information.
11. If caster fork tapered bearing seals leak, refer to the Super 104™ General Service Manual (p/n 125816) for repair procedures.
12. Refer to the General Service Manual (P/N 125816) to service or repair the tapered wheel bearings.
* After completing maintenance cycle (500 hours), repeat cycle.