REV B 9-2 125816
Uneven cutting height The blade(s) are not sharp Sharpen the blades
A cutting blade(s) is/are
bent
Install new cutting blade(s)
The deck is not level Level the deck per the Deck
leveling and height adjust-
ment section of the General
Service Manual
An anti-scalp wheel is not
set correctly
Adjust the height of the
anti-scalp wheel
The underside of the deck
is dirty
Clean the underside of the
deck
Tires improperly inflated Adjust air pressure to drive
tires 15–20 psi (103–138
KPa). Front tires 20–25 psi
(138–172 KPa)
A blade spindle is bent Contact your dealer
Flex Forks
®
are installed
Level the deck per the Deck
leveling and height
adjustment section of the
General Service Manual
SYMPTOMS PROBABLE CAUSES
SUGGESTED
REMEDIES
To Next Page
Loading...
