606835 4-11 REV B
4. Change engine oil filter per the engine manufacturer’s recommendations. Refer to Engine Owner’s Manual for recommendations and other
maintenance items.
5. Service more often under dusty or dirty conditions. Use caution when servicing to prevent dust contamination in the engine. Do not clean filter
element. Replace with a new one.
6. Pump drive belt only - Inspect every 100 hours and replace if worn or cracking is noticed. Check spring tension adjustment. Otherwise, replace
belt every 400 hours or 2 years whichever comes first. Check and adjust the spring tension after 50 hours of use as outlined in the Hydraulic
Pump Belt Adjustment section of the Super 104™ General Service Manual (p/n 123942).
7. Check fuel system for any crack or leaks including, but not limit to, fuel line hoses, fuel valve, vent line hoses, vent valve, vapor valve, carbon
canister, and grommets. Replace as needed.
8. More often under dusty or dirty conditions and during hot weather.
9. Inspect ROPS after the first 20 hours of operation and then after every 500 hours of operation or yearly whichever comes first.
10. Refer to engine owner’s manual for engine service information.
11. If caster fork tapered bearing seals leak, refer to the Super 104™ General Service Manual (p/n 123942) for repair procedures.
* After completing maintenance cycle (500 hours), repeat cycle.
To Next Page
Loading...
Need help?
General
