--------------------------------------------------------------
The manufacturer is not liable for damage caused by unauthorized tampering with
the device(s). Such tampering will forfeit any rights to claim under warranty.
be used together with accessories supplied by Huvitz
If the customer makes use of other accessories, use them only if their safe
usability under technical safety aspects has been proved and confirmed by Huvitz
or the manufacturer of the accessory.
persons who have undergone proper training and instructions are authorized
to install, use, operate, and maintain this equipment.
s Manual and Service Manual in a place easily accessible at all
times for persons operating and maintaining th
Do not force cable connections. If a cable does not connect easily, be sure that the
connector (plug) is appropriate for the
(socket). If you cause any
damage to a cable connector(s) or receptacle(s), let the damage(s) be repaired
an authorized service technician.
Please do not pull on any cable. Always hold on to the plug when disconnecting
Before every operation, visually check the equipment for exterior mechanical
damage(s) and for proper function.
ventilation grids or slits.
Immediately turn off and unplug any equipment that gives off smoke, sparks,
strange noises, or odors.
Power Supply Cord set (international)
(Detachable) Rated 10 A, 250 V. Plug type
CEE 7/VII, Connector type IEC 60320/C13, a
conductor terminating in molded
on grounding type attachment plug.
<HAR> marked on the cord. Maximum 4.0 m long
To Next Page
