Set device network parameters:
• IP address / HTTP port (80 by standard)
• Your network mask
• IP address of your network gateway
• Device name (optional parameter)
Save the settings by clicking on Apply Changes.
Note: The device provides 2 options how to restore its default settings:
1) Right-click on the device’s MAC address. Click to Load default values item.
Note: Device default values can be restored from the HWg-Config program only during
first 60 settings after device powered-up.
2) Switch off the device. Press the RESET button on the device, hold it down and connect
the device power source (power adaptor). Hold the button down for another 5 seconds
until all the LEDs light up.
To Next Page
Loading...