SMS Test Log
In this section, the SMS gateway settings can be tested.
• Test SMS – Sends a test text message to the specified Phone number.
• Test Call – Dials the specified Phone number.
• Debug log window – This shows the communication with the SMS gateway.
Alarms tab
This tab is used to set alarm targets. Up to 3 sets of destinations can be created and each set
can contain up to 5 email destinations and 5 phone number destinations for SMS and voice call
alarms.
These sets are then assigned to individual sensors and Digital Inputs. The set is created either
by pressing the + button on the Alarms page or by selecting Add new... on the Sensor or
Digital Input edit page.
Alarm Target
A set of targets. The set can be named for better clarity.
• Email list - A set of email addresses to which alarm messages will be sent. The SMTP
server on the Email tab must be set up correctly for the email to be sent.
- Email address - The field can only contain one email address at a time.
• SMS list - A set of phone numbers to which alarm messages will be sent. To send SMS,
the SMS gateway must be set up correctly on the SMS tab.
- Phone number - The field may only contain one phone number at a time.
- Call - If checked, the phone number will ring after the SMS is sent (the user does
not need to hear the incoming SMS). The ringing lasts for about 20 seconds for
each individual number and then it is terminated. Answering the call only ends the
ringing, no voice message is sent.
To Next Page
Loading...