WWW interface
Home tab
General Info section
• Device Name: This setting allows you to assign a unique name to the device, which can
be helpful when managing larger installations. You can configure the device name on the
General Setup tab.
• Time: Displays the current time of the device. You can set it manually on the Time tab, or
you can choose to synchronize it automatically with the Internet. If the automatic
synchronization is successful, the displayed time indicates that the device has Internet
access.
• Date: Shows the current date of the device. You can set it manually on the Time tab, or
you can synchronize it automatically with the Internet. If the automatic synchronization is
successful, the displayed date indicates that the device has Internet access.
Sensors & Digital Inputs section
• State – Current state of the input or sensor.
- Normal - Quiet state, everything is fine.
- Alarm High - The value has exceeded the upper allowable limit.
- Alarm Low - The value has dropped below the lower allowable limit.
• Name - The name of the sensor used for better identification in larger systems. The name
can be set on the Sensors page.
• Type - Sensor Type; determines what type of sensor it is (temperature/humidity/digital
input, etc.).
• Current Value - The current value including measured quantity.
To Next Page
Loading...