© EUROHEAT DISTRIBUTORS (H.B.S) LTD. Nov 2006
E & OE Instructions Part number IN1141 Ed B
12
Wearing the stove glove place a few logs larger than kindling
wood over, but not smothering the kindling.
When the previous loading of wood is burning brightly add two
larger split logs to bridge the fire. Always avoid putting wood
directly onto wood burning with flame, try and leave air space
under the wood for the flame to form, because the new, cold
log will tend to cool the fire.
Reduce the burn rate control setting when the fire is established to the desired heat output and set the air wash
control to the mid setting. See the individual lighting and operating instructions for the stoves on the following
pages.
Putting new logs bark side down, will give you both maximum
efficiency and best visual effect as it begins to burn.
At the rear of the combustion chamber you will observe that the
are a series of holes or slots, these are there to allow air into the
combustion chamber and should NOT be covered at any time
To Next Page
Loading...
