HYCO SPEEDFLOW UNVENTED WATER HEATER
MODELS SF10K (10 Litres) AND SF15K (15 Litres)
1. INTRODUCTION
operates at mains water pressure and can supply hot water to two or more basins
using ordinary taps.
CAUTION
THE SPEEDFLOW MUST BE INSTALLED AND MAINTAINED BY
A COMPETENT PERSON IN ACCORDANCE WITH CURRENT
ELECTRICAL AND PLUMBING REGULATIONS.
IT IS ESSENTIAL THAT THE ENCLOSED PRESSURE RELIEF VALVE
IS FITTED
MAKE PLUMBING CONNECTIONS WITH FLEXIBLE STAINLESS
STEEL HOSES TO FACILITATE FUTURE MAINTENANCE
ALWAYS FIT THE HEATER THE CORRECT WAY UP
(PIPES SHOULD BE AT THE TOP)
USE LOWEST ACCEPTABLE TEMPERATURE SETTING TO SAVE
ENERGY AND REDUCE LIMESCALE
DO NOT CONNECT TO POWER UNLESS UNIT IS FULL OF
WATER – OPEN TAP AND ALLOW WATER TO FLOW FREELY
TO CLEAR AIRLOCKS
DO NOT SWITCH POWER ON IF WATER IN HEATER OR PIPES
COULD BE FROZEN
2. INSTALLATION (WALL MOUNTING)
it can be mounted above or to the side of the outlet provided it is vertical with
ENSURE THE MOUNTING SURFACE IS STRONG ENOUGH TO
SUPPORT THE SPEEDFLOW INCLUDING THE WEIGHT OF
THE WATER.
(SF15K) can typically serve 2 or 3 depending on simultaneous usage.
1
To Next Page
Loading...
Need help?
General
