How to fix mixing valves not working in Hyco Water Heater?
If the mixing valves on your Hyco Water Heater aren't working, it could be due to unbalanced pressure. Make sure the cold water is correctly tee-ed off after the pressure reducing valve, so both hot and cold water are at equal pressure.
Why is my Hyco Powerflow Water Heater not heating?
If your Hyco Water Heater isn't heating water, it could be due to several reasons. The thermal cut-out may need resetting. Alternatively, there might be an element, thermostat, or thermal cut-out failure, requiring replacement. Also, check that there is an electrical supply.
What to do if Hyco Water Heater discharges water all the time?
If water is constantly discharged from your Hyco Water Heater, it could be because the pressure reducing valve isn't properly reducing water pressure, or a safety valve is operating below its nominal level. You may need to replace the appropriate valve.
Why is the water from my Hyco Powerflow too hot?
If the water from your Hyco Water Heater is too hot, the thermostat might be set too high. Try reducing the setting. Consider fitting a thermostatic mixing valve.
What to check if there is no water flow from Hyco Powerflow?
If you're experiencing no or limited water flow from your Hyco Water Heater, ensure the mains water is turned on and check the pressure reducing valve for grit.
Why Hyco Water Heater discharges water only during heating cycle?
If water is being discharged only during the heating cycle of your Hyco Water Heater, the expansion vessel may have lost its charge.
Summary of components and general installation requirements.
Detailed instructions for securely mounting the water heater to a wall.
Procedure for safely draining the water heater.
Safety advice for maintaining electrical parts.
General| Power | 3kW |
|---|---|
| Warranty | 2 years |
| Frequency | 50 Hz |
| Thermostat | Adjustable |
| Overheat Protection | Yes |
| Indicator Light | Yes |
| Approvals | CE |
| Voltage | 230-240V |
To Next Page
