Hycontrol MICROFLEX-D Series - Technical Specifications

9 / 10
10. SPECIFICATIONS
Frequency
 50 kHz
Operating Voltage
 7 - 28VDC at the terminal (residual ripple no greater than
100mV)
Power Consumption
 500mW @ 24VDC
Analog Output
 4 -20mA modulating output module with HART (Recommended
250 Ohm @ 24VDC)
Analog Resolution
 14 bits
Communications
 4 -20mA with HART
Blanking Distance
 250 mm (10")
Maximum Range
 8 metres (26’) or 12 metres (40’)
Resolution
 1 mm (0.04”)
Electronic Accuracy
 +/- 0.25% of maximum range
Operating Temperature
 -40°C to 60°C (-40°F to 140°F)
Maximum Operating Pressure
 -0.5 to 3 bar (0 - 44 PSI)
Automatic Temperature Compensation
 Yes
Beam Angle
 7°
Materials
 Transducer: PVDF
 Housing: Powder coated aluminium
Display
 4-line graphic display (128 x 64)
Keypad
 4 keys = CAL, RUN, UP, DOWN
Memory
 >10 years data retention
Enclosure Sealing
 IP67
Cable Entries
 M20 cable glands
Mounting
 2” BSPT Thread or 2” NPT Thread
Typical Weight
 1kg (2.2 pounds)
Volume
 Pre-set common vessel shapes
 Requires PC connection with Vision System II software
 32-point programmable linearization table