Boxxer 427 Page 3-1
HydraMaster Corporation
Operating Instructions
Boxxer 427
Section 3-1
START UP
1. Perform daily and periodic maintenance as specified in this Owner’s Manual.
2. Connect all required hoses, including a garden hose for water supply.
3. Connect the cleaning tool to the length of hose required to perform
the cleaning.
Water box must be full prior to ignition.
The machine cannot be run in the “IDLE” position for cleaning upholstery, carpet or
floor extraction. This will void the warranty.
NOTE: In order to achieve consistent adjustable temperatures, an operating pressure
of 200 PSI must be maintained.
Note: Never run machine on any speed other than full throttle. Running at any
other speed will void the warranty.
Carpet or Hard Surface Cleaning
1. Start the engine with throttle cable in “IDLE” position.
Allow machine to run in idle for 2 - 3 minutes to warm up.
2. Connect hoses.
3. Connect wand or tool.
4. Pull THROTTLE to “HIGH” position.
5. If used, turn PUMP IN switch to “ON” .
6. Turn PUMP switch to “ON” .
7. Turn DIVERTER switch to “ON” .
8. Set temperature to desired level.
9. If used, turn PUMP OUT switch to “ON” .
WARNING
!
CAUTION
!
To Next Page
Loading...
