- 16 -
Press until “heat” or “Cool” light is on.
6.4 Setting the real time
On standby or running mode, long press for 10 seconds, then press or to adjust
hour/minute.
Then press the
again to store the new data.
When setting the time,
and cannot work.
6.5 Water temperature setting:
On standby or running mode, press and to adjust the desired water temperature
Note : the heat pump can running only if the water circle/filtration system is running.
6.6 Automatic start/stop the heat pump
To set the time to start the unit
Press to set the time to start the unit, then press or to adjust the time (set the time for
start
5 minutes after the water pump).
Press
again to store the new data.
To set the time to stop the unit
Press to set the time to stop running, then press or to adjust the time (set the time for
stop
5 minutes before the water pump).
Press
again to store the new data.
6.7 Concell the automatic start/stop
To concell the automatic starter
Press
, then press , light off and the automatic start is off.
To concell the automatic starter
Press
, then press , light off and the automatic stop is off.
To Next Page
Loading...
