深圳市宏宇达数控技术有限公司
地址：深圳市南山区中山园路 1001 号 E4-6C(TCL 国际 E 城) TEL：755-26625800 FAX：755-26729960
-25-
4.3.、The connection between XPTHC-4 and HYD2000 series wiring
XPTHC-4 to HYD2100、HYD2200、HYD2300、HYD2500 see Fig 4-4 shows:
Fig 4-4 ：XPTHC-4 to ARM CNC controller connection
Note：1、It’s the direct connection.
2、It requires the CNC controller output signal is low-level effective.
3、If don’t change the corner logic on CNC, then please set the “P7” to “0”
on THC
5、Important :
1、XPTHC-4 is a new and smart THC with full function, while it’s designed for small
motor(<25W), so please don’t use it for the lifter which motor is more than 30W, in avoid
to any damaged.
2、XPTHC-4 performance is no relationship with plasma’s current
3、Welcome to any suggestion and comment, it’ll help our company design and develop
good products to customers.
Shenzhen HYD CNC Technology Co., Ltd
To Previous Page
