Need help?Do you have a question about the HYFIX MobileCM Base-Station and is the answer not in the manual?
Locate and record the unique station serial number found on the device for installation records.
Connect the USB-C cable and turn on the device. Observe LED indicators for power and initial mode.
Identify and connect the WiFi and GNSS antennae to their respective ports on the MobileCM.
Understand the meaning of the RED, ORANGE, and GREEN LED indicators for device status.
Information about an upcoming Android setup application for device configuration.
Connect to the MobileCM's temporary WiFi network and configure its connection to your local network.
Access the MobileCM's web interface to manage settings after it connects to your WiFi network.
Enter a unique Miner Key for Geodnet association and confirm data transmission is active.
Learn how to change the MobileCM's WiFi connection to a new network or location.
Select an installation spot with a clear 10-degree elevation angle for optimal GNSS signal reception.
Properly install the GNSS antenna vertically using provided hardware for stable signal acquisition.
Understand how to extend the antenna cable length using compatible TNC adapters and cables.
Explore resources on terrestrial GNSS ground network data and its relevance to space weather.
Learn about networks that provide GNSS corrections for precise positioning applications.
Connect via USB COM port to diagnose issues, check status, and retrieve device information using commands.
Execute specific serial commands to reset configuration, check WiFi status, or retrieve the serial number.
To Next Page
General