To Next PageTo Next Page
Need help?Do you have a question about the Hygger HG-957 and is the answer not in the manual?
General| Model | HG-957 |
|---|---|
| Type | LED Aquarium Light |
| Voltage | 100-240V |
| Overheat Protection | Yes |
| Indicator Light | Yes |
| Adjustable Timer | Yes |
| Dimmable | Yes |
| Category | Aquariums |
| Material | Aluminum |
LCD monitor allows independent control for sunrise and sunset simulation.
Strong LEDs provide incredible brightness for better viewing experience.
Ten brightness levels and seven colors for various lighting needs.
Light On/Off adjustable via integrated LCD Display.
High-quality LEDs provide stable, consistent lighting.
High CRI, efficient lighting saves energy with DC adapter.
Bracket allows light to fit a wide range of aquariums.
Lighting program is saved in case of power loss.
Provides full spectrum for healthy aquatic plants.
Special care needed with water; do not attempt repairs if damaged or malfunctioning.
Place aquariums away from outlets; use drip loop to prevent water contact.
Not for impaired persons without supervision; children must be supervised.
Do not touch moving or hot parts.
Disconnect from power before maintenance; grasp plug firmly to disconnect.
Indoor use only; avoid freezing temps; do not immerse.
Ensure secure mounting before operation.
Use properly rated cords; arrange to avoid tripping.
Outlet should be near equipment and easily accessible.
Mount on aquariums with glass >3mm; avoid electrical shock if wet.
Identifies key buttons and display elements on the control panel.
Preset timer operation for daylight and moonlight simulation.
Procedure to set the local time and time format (12H/24H).
Steps to set the hour and minute for local time.
Visual representation of the daylight and moonlight timer cycles.
Option to adjust start and end times for daylight/moonlight.
Procedure to set the start and end times for daytime lighting.
Procedure to set the start and end times for nighttime moonlight.
How to choose moonlight color and adjust time.
Steps to switch from Standard mode to Manual mode.
Procedure to activate the DIY mode.
System proceeds to set 8 light stages with intensity and timing.
How to turn the light off and back on.
Temporarily adjust light intensity levels.
Temporarily change color temperature and cycle through colors.
Procedure to reset the device to factory settings.
Verify components are undamaged before operation.
Ensure correct and secure mounting on the aquarium.
