II
Table of Contents
1. INTRODUCTION _____________________________________________________ 1
1.1 WHAT IS ATP? _____________________________________________________ 2
1.2 HOW DOES THE LUMINOMETER WORK? ____________________________________ 2
1.3 WHAT IS AN RLU? __________________________________________________ 2
1.4 TEST DEVICES AND ACCESSORIES _________________________________________ 3
2. LUMINOMETER DESCRIPTION _________________________________________ 4
2.1 KEYPAD SYMBOLS ___________________________________________________ 4
2.2 INSTALLING BATTERIES ________________________________________________ 5
2.3 TURNING THE LUMINOMETER ON AND OFF __________________________________ 6
2.4 DISPLAY LAYOUT AND ICONS ____________________________________________ 7
2.5 LOW BATTERY INDICATOR ______________________________________________ 7
2.6 POWER SAVING STANDBY MODE _________________________________________ 8
2.7 INTERNAL CALIBRATION _______________________________________________ 8
2.8 LOW MEMORY WARNING _____________________________________________ 8
3. SET-UP MENU OPTIONS ______________________________________________ 9
3.1 USER ID _________________________________________________________ 10
3.2 SETTING UP PROGRAM TEST POINTS AND PASS/FAIL LIMITS _____________________ 10
3.3 TEST PLANS ______________________________________________________ 11
3.4 ESTABLISHING ATP PASS/FAIL LIMITS ____________________________________ 12
3.5 VIEWING STORED TEST RESULTS ________________________________________ 12
3.6 VIEWING STATISTICAL DATA AND TEST FAILURES _____________________________ 12
3.7 ERASING THE TEST RESULTS MEMORY ____________________________________ 13
3.8 SETTING THE CLOCK TIME AND DATE _____________________________________ 13
3.9 ADJUSTING THE LCD CONTRAST ________________________________________ 14
3.10 QUICK BOOT ____________________________________________________ 14
3.11 STANDBY MODE __________________________________________________ 14
3.12 BOLD TEXT ______________________________________________________ 15
3.13 SAVE TESTS _____________________________________________________ 15
4. SAMPLE MEASUREMENTS AND TEST RESULTS ___________________________ 17
4.1 TAKING A SAMPLE MEASUREMENT _______________________________________ 18
4.2 PERFORMING A RETEST ______________________________________________ 19
5. INSTALLING SURETREND DATA ANALYSIS SOFTWARE _____________________ 19
5.1 CONDITIONS OF USE ________________________________________________ 19
5.2 HARDWARE AND SOFTWARE REQUIREMENTS ________________________________ 20
5.3 STARTING THE INSTALL PROCESS ________________________________________ 20
To Next Page
Loading...
Need help?
General
