What to do if my HYOSUNG Motorcycle shows malfunction code 0230?
If your HYOSUNG Motorcycle is showing malfunction code 0230, this indicates a fuel pump relay signal open or ground short fault. Check the fuel pump relay, connecting lead wire, and the power source to the fuel pump relay.
What to do if HYOSUNG 2010 ST7 shows malfunction code 0563?
If your HYOSUNG Motorcycle shows malfunction code 0563, it means that the battery voltage is high. You should check the battery and the wiring/coupler connection to the ECU.
General| Engine Type | V-Twin, 4-stroke |
|---|---|
| Displacement | 678.2 cc |
| Bore x Stroke | 81.5 x 65 mm |
| Compression Ratio | 11.5:1 |
| Fuel System | Fuel injection |
| Transmission | 5-speed |
| Final Drive | Chain |
| Rear Suspension | Dual shocks |
| Rear Brake | Single disc |
| Rear Tire | 170/80-15 |
| Lubrication | Wet sump |
| Clutch | Wet Multi-Plate |
| Front Tire | 120/70-18 |
| Fuel Capacity | 17 liters |
| Horsepower | 62.5 hp @ 8000 rpm |
| Engine | 4-stroke |
| Frame | Steel |
| Ground Clearance | 150 mm |
| Dry Weight | 244 kg |
| Ignition | Digital |
| Front Suspension | Telescopic fork |
Illustrates the various components of the motorcycle.
Provides essential safety guidelines and procedures for vehicle servicing.
Details key technical specifications for the motorcycle's dimensions, engine, and transmission.
Outlines recommended intervals for all required periodic service work.
Describes service procedures for various maintenance items like valve clearance and spark plugs.
Detailed steps for safely removing and reinstalling the engine assembly.
Covers inspection and service procedures for various engine components.
Guidance for diagnosing and resolving issues within the EI system.
Lists malfunction codes, detected items, and failure conditions for diagnosis.
Details on the fuel system components and their assembly.
Instructions for removal, cleaning, inspection, and installation of the throttle body.
Information on engine coolant type, capacity, and freezing/boiling points.
Procedures for removing, inspecting, and cleaning the radiator.
Details on inspecting, removing, and installing the cooling fan assembly.
Diagrams showing the location of various electrical components on the motorcycle.
Inspection procedures for the magneto and ignition coils.
Tests for charging output, magneto no-load performance, and regulator/rectifier.
Description and circuit diagrams for starter and side stand interlock systems.
Guidance on battery treatment, electrolyte handling, and recharging operations.
Instructions for removing, disassembling, and inspecting the front wheel and related parts.
Details on the front brake system, including caliper removal and reassembly.
Procedures for removing, disassembling, and reassembling the steering system.
Diagnostic tables for malfunction codes and common vehicle complaints.
Lists all special tools required for servicing with part numbers.
Provides standard torque specifications for various engine and chassis components.
To Next Page
