defective the charger may correctly refuse to charge it based on safety algorithms.
(5) Try another RC battery type. For example switch to a NiMH battery if you are failing to charge Lithium types. Success
) Contact your dealer with full details and description of the problem, including the type of input power source, RC battery
RROR MESSAGES
with one type but failure with another generally indicates that the charger is working properly. The failing battery type is
almost certainly in poor condition, then, or you have improperly set the charger for it.
(6
type and cell count, and history of the charger – specifically, has the charger been working properly before, or failing from
new condition?
E
INPUT VOLTAGE ERROR Input voltage is below 11.0V or exceeds 15.0V
NO BATTERY Battery not detected
OUTPUT BATT REVERSE POLARITY Battery is connected in reverse polarity to Output leads
OUTPUT CIRCUIT PROBLEM Non-Specific Circuit error. Check battery condition
CHECK BATT OPEN CIRCUIT Battery disconnected during charging
CHECK BATT OVER VOLTAGE Battery voltage too high to match charger settings
CHECK BATT LOW VOLTAGE Battery voltage too low to match charger settings
BALANCER VOLTAGE TOO HIGH
If voltage per cell is too high during balancing, this message may appear.
BALANCER VOLTAGE TOO LOW
If cell’s voltage falls too low during balancing, this message may appear
DON’T CHARGE Lixx WITH THIS MODE
A Lithium pack is connected by balancer, but NiCd/NiMH/Pb mode is selected for charging
Note: If the incorrect number of cells is selected for a lithium type battery, and charging is begun, the charger may give error
ALANCE MULTI-CONNECTORS
for most common lithium pack brands are available from your dealer: #HP-EOSLBA-26xx
P: fit HYPERION, POLYQUEST, PolyQ, ETEC, and some other brand packs.
all FLIGHTPOWER* packs from 2S to 6S.
ch Note*: Due to the wiring arrangement on some Thunderpower and FlightPower 4S packs only, the 4S packs may need
ARRANTY
YPERION Chargers are guaranteed to be free from defects in materials and workmanship for a period of one calendar year
amage due physical shock (dropping on the floor, etc), inappropriate power supply (automotive battery charger, etc!), water,
njoy the Power!
he Hyperion Team
immediately and stop charging. In some cases, however, the charger will begin charging at the (lower) voltage it sees as
correct, and watch all cells to confirm the incorrect setting. For example, if you connect a 3S pack but set the charger for 4S
by mistake, the charger may begin by charging at 3S voltage level, and watch all cells. When the mistake is confirmed, the
charger will give error and terminate. This is normal and correct behavior.
B
Hyperion Balance Multi-Connectors
Applications list below may be subject to change, depending on maker decisions outside our control. If your brand is NOT
listed, email your battery maker to ask them WHICH OF THE BRANDS BELOW they are compatible with.
H
EH: fit KOKAM, GRAUPNER and ROBBE
XH: fit ALIGN and DUALSKY packs
TP: fit recent THUNDERPOWER and
Te
the 6th wire removed in order to function properly with HP-EOSLBA-26TP MultiAdapter for 4S charging.
SEE DIAGRAM at http://media.hyperion.hk/dn/eos/eoslba26/EOSLBA26TP-FP4Smod.gif
W
H
from date of purchase. Your selling dealer is your first point of contact for warranty issues. Return postage costs are the
responsibility of the user in all cases. Submit copy of original receipt with the return.
D
moisture, and humidity are specifically NOT covered by warranty. It is well to carefully check your charger before making a
return, as problems in setup, cabling, or power supply are much more common than defects in the charger.
E
T
To Previous Page
Loading...
Need help?
General
