HyperX Cloud Core Wireless User Manual

Document No. 480HX-HHSC1C.A01
HyperX Cloud Core Wireless
Page 17 of 17
Manually Pairing the Headset and USB Adapter
The headset and USB adapter are automatically paired together out of the box. But if manual pairing is
needed, follow the steps below to pair the headset and USB adapter.
1. While the headset is powered off, hold down the power button until the headset status LED
starts blinking red/green rapidly. The headset is now in pairing mode.
2. While the USB adapter is plugged in, use a small tool (e.g. paper clip, SIM tray ejector, etc.) to
hold down the button inside the pin hole until the USB adapter LED starts blinking rapidly. The
USB adapter is now in pairing mode.
3. Wait until both the headset LED and the USB adapter LED are solid.
The headset and USB adapter are now paired together.
Questions or Setup Issues?
Contact the HyperX support team at: hyperxgaming.com/support/

HyperX Cloud Core Wireless Specifications

General

Driver Size	53mm
Battery Life	Up to 20 hours
Wireless Range	Up to 20 meters
T.H.D.	< 2%
Weight	283g
Microphone Sensitivity	-42dBV (1V/Pa at 1kHz)
Wireless Technology	2.4 GHz
Form Factor	Over-ear
Frequency Response	10Hz - 21kHz
Impedance	60 Ω
Microphone Type	Detachable, Noise-cancelling
Connection Type	Wireless
Microphone Element	Electret condenser
Microphone Polar Pattern	Noise-cancelling