HyperX Cloud Orbit S

Document No. 480HX-HSCOS.A01
HyperX Cloud Orbit
TM
HyperX Cloud Orbit S
TM
Page 8 of 14
Nintendo Switch USB Setup
1. Power on the headset.
2. Hold down the microphone volume wheel for 2 seconds to change audio modes. Repeat this
step until the headset plays the voice prompt “2 Channel”.
3. Connect the headset to the Nintendo Switch dock via the USB Type-C to Type-A cable.
4. Hold the HOME button on the controller for 1 second to access the Quick Settings menu.
5. Go to the USB volume control and set the level to maximum.