Installation, Operation, Repair And Parts Manual
7/05
Description
Series 5300C-X, 5321C, 5322C and 5324C
Small Twin
®
Piston and Plunger Pumps
Form L-0200P
The following special attention notices are used to notify
and advise the user of this product of procedures that
may be dangerous to the user or result in damage to the
product.
NO
TE: Notes are used to notify of installation, oper-
ation,
or maintenance inf
ormation that is impor
tant
but not safety related.
CA
UTION:
Caution is used to indicate the presence
of a hazar
d,
whic
h will or can cause minor injury or
property damage if the notice is ignored.
WARNING: Warning denotes that a potential hazard
exists and indicates procedures that must be fol-
lo
wed e
xactl
y to either eliminate or reduce the haz
-
ard, and to avoid serious personal injury, or prevent
future safety problems with the product.
D
ANGER:
Danger is used to indicate the presence
of a hazard that will result in severe personal injury,
death, or property damage if the notice is ignored.
Safety Information
SERIES 5321C & 5322C
Cast Iron Small Twin
Plunger Pump
Max. Flow Rate: ........................2.2 gpm
Max. Pressure: ........................1000 psi
Max. Speed: ............................1725 rpm
Ports:................................1/2" NPT inlet
1/2" NPT outlet
Max. Operating Temp. ................180
o
F
SERIES 5300C-X
Cast Iron Small Twin
Piston Pump
SERIES 5324C
Cast Iron Small Twin
Piston Pump
Max. Flow Rate: ........................2.9 gpm
Max. Pressure: ..........................800 psi
Max. Speed: ............................1725 rpm
Ports:................................1/2" NPT inlet
1/2" NPT outlet
Max. Operating Temp. ................140
o
F
Max. Flow Rate: ..................1.5, 2.0, 2.5
and 3.0 gpm
Max. Pressure: ..........................500 psi
Max. Speed: ............................1725 rpm
Ports:................................1/2" NPT inlet
1/2" NPT outlet
Max. Operating Temp. ................140
o
F
DANGER: DO NOT pump flammable or explosive
fluids such as gasoline, fuel oil, kerosene, etc. DO
NOT use in explosive atmospheres. The pump
should be used onl
y with liquids compatible with the
pump component materials. Failure to follow this
warning can result in personal injury and/or proper-
ty dama
g
e and will v
oid the pr
oduct warranty
.
A pressure relief device, such as an unloader, relief
valve or balancing regulator must be installed on the
outlet side of the pump.
F
ailure to do so could
result in per
sonal injur
y and/or v
oid the warranty
.
•
Be sure all exposed moving parts such as shafts,
couplers and adapters are properly shielded or
guarded and that all coupling de
vices are securely
attached before applying power.
• Hollo
w shaft pumps mounted directly onto po
w
er
shaft m
ust be pre
v
ented from rotating with the po
w
er
shaft by means of a device such as a torque arm.
Pump m
ust float freely on the po
wer shaft and must
not be tied r
igidly to equipment on which it is mount
-
ed.
AG_200P_0705.qxp 6/30/05 3:36 PM Page 1
To Next Page
General
