Hyster H2.5XT - Changing Fuel for Dual Fuel Truck; Inspection

How to Drive 5
─
67
─
6. Conrm that there are no water leaks on the joints of the hot water hose ends
between the engine and regulator.
7. Check that there is no trouble on the electrical wiring sheaths or connections,
and conrm that sparks are not generated.
Changing Fuel for Dual Fuel Truck
1. Set the key switch to
“ON”, set the
fuel changeover switch to “OFF” to
shut off the supply of both LPG and
gasoline.
2. Start the engine and allow it to stop
naturally so that the fuel in the fuel
line is used up.
3. Set the fuel changeover switch to
LPG or GASOLINE.
4. Start the engine.
If the fuel changeover switch is set to LPG or GASOLINE before the fuel in
the fuel line is used up, the engine may malfunction and is dangerous.
CAUTION
This lift truck can be operated on either LPG or gasoline, but the engine is
set for the optimum performance with LPG.
Consult with your authorized service dealer when using the lift truck with
gasoline constantly for a long period.
CAUTION
● LP gas has a distinctive odor, but detection fluid should be used for
inspection.
● Never inspection for leaks with re such as with a match.
● Do not start the engine until the fuel leak is repaired.
WARNING